Hello,
From the Puppy Linux Users Group on Facebook (150+
):
Jay Stansbury BTW, I am running 527 ATM, a reboot fixed it, for now!!!
about an hour ago · Like
Jay Stansbury Run the wizard once, full GUI, run it again, and a partial GUI... Reboot, and a full GUI again.... once....
46 minutes ago · Like
Jay Stansbury Rebooted 5.2.7 again... This time, the wireless card didnt initialize.. the wizard was partial.. "ifconfig wlan0 up" brought the card up.. Ran the wizard again, and it was COMPLETE!!! (doesnt work in 3.6.4 Precise or 3.6.4 Squeeze.) Is there an error message somewhere?? Running in a terminal PRODUCES NO ERRORS!!!!! It just dont work, so the GUI is missing because an underlying piece of software (wpa_supplicant????) is failing... I am going to start again clean.. My 3.6.2 kernel, and the Pups I woofed from it WERE FINE. Built 3.6.4, woofed Precision from it, and all hell breaks loose. The problem occurred after woofing with 3.6.4, so I will remove everything related to that process.. Will stick the whole shebang on a jumpdrive, and start over... I am pissed off royally that a completely different Puppy, which had functioned for about 2 weeks flawlessly, while I built all kinds of stuff with it, and was building a Trekpup upon, went sour after woofing Precision, on a different Pup, (which was the first place I had the error occur...) and remains jacked up..
That is impossible....... Period... Frugal installs are separate, isolated... Dpup with 3.6.2, Precise, Lupen, and so many others are fine...
I am "bumfuzzled"..............
I think I am going to build on a kernel 3.x.x series Wary.. Been building on Lupen and Dpup Exprimo...Gonna create a clean, new, generic, "Built By BarryK" build environment... I`m not adding squat to these builds.. It has to be something in my build environment..???
Virtually everything (except Archpup) I have ever woofed, or even unleashed, has worked, or failed in known ways (Napu/xorg).. Till I woofed with 3.6.4.