Hi Rob,ProgRob wrote:Like some others on here I have a laptop that needed a non-PAE version of MacPup. So I have created two non-PAE versions of MacPup 529 based on different kernels.
The first is based on kernel 3.2.32 which is the same kernel used in retroPrecise Puppy. You can download the iso from here: https://www.dropbox.com/s/djk1052u6r9d0 ... 3.2.32.iso
As far as I can tell it works just like normal Macpup 529 except that it will run on a processor that does not support PAE. If it works for you then use this version.
However, for me, retroPrecise Puppy won't connect to the internet on the laptop that needed this (due to driver problems). So I also produced a version which used the kernel from Macpup 511 which is kernel 2.6.33.2. You can download this iso from here: https://www.dropbox.com/s/q9vp0gg37ln1u ... 6.33.2.iso
Again, this seems to work fine with the one change that the save file uses a hyphen (-) rather than an underscore (_). Try this if the other version doesn't work.
I'm a bit new to all this so I may have made a mistake in re-engineering these but hopefully they will be useful to people. They seem to run fine for me.
Cheers,
Rob
I have downloaded both of these ISO's twice and burned them to disk, but when I try to boot from them I get the "Loading Stage 2...." message then they just hang. I know it is not a hardware issue as other ISO's burn and boot fine. I could really use these NON-PAE distros, so hope this issue can be fixed.
Thanks for the time and attention.
cheers, Paul