Page 1 of 1
crash upon reboot after package install
Posted: Sat 25 Jun 2011, 15:17
by maybeme
Sorry if this has been posted before...but I have an issue with my Lucid 5.2.5 (installed to SD) that I can't figure out out: everything is fine UNLESS I install any software that asks for a reboot. Then I get the error messages attached - fatal pci module errors, dumping kernel log, etc. Software installs that don't ask for a reboot are fine.
Anybody know where I should start looking (and yes, I'm pretty much a newbie).
Thanks,
Bernie
Posted: Sat 25 Jun 2011, 18:55
by bigpup
Details about how you are installing programs?
What program does this? Give name.
Where are you getting programs?
Posted: Sat 25 Jun 2011, 20:39
by maybeme
Sorry - should've clarified: any of the programs requiring a reboot made available in Quickpet v4.5 - last 2 it happened with were Gimp and Acrobat Reader.
Posted: Sun 26 Jun 2011, 13:18
by Karl Godt
Gimp as far as I know is pretty large .
Wow much free space did you have after the installation ?
Did you install as .pet or .sfs ?
Make sure your save-file is not getting corrupted .
Use 'tune2fs -c 20 -i 5d -j -L 525pupSave -m 7 -o debug,acl,journal_data_ordered -O +dir_index,+filetype /Path/To/My/Pupsave-file'
to convert it into ext3 .
Run fsck .
To me it looks , that some initrd.gz/init mount everything into tmpfs in RAM not only @frugal usb installations but also @frugal hd installations .
the output of the commands < df > and < mount > would be useful to check what would /pup_ro1 .. ro4 be .
pup_ro2 should be the main.sfs , pup_ro1 the savefile.2fs , and pup_ro4 the zdNUMBER.sfs or the devx.sfs .
Posted: Sun 26 Jun 2011, 13:27
by Bruce B
Seems to me I had this problem one time because the squash file was not version 4, but my recall is a little hazy on this.
Something I'd look into.
~
Posted: Sun 26 Jun 2011, 20:42
by Sylvander
1. "Anybody know where I should start looking"
I got that warning with Legacy OS 2 at the 1st attempt at boot...
From either a CD-RW or CD-R.
2. The problem disappeared when I used a Smart Boot Manager [SBM] bootable floppy to choose the device to boot [this or that optical drive].
3. Subsequently, there was no longer any need to use the SBM floppy; the CD's would boot just fine without it.
Posted: Mon 27 Jun 2011, 04:57
by maybeme
Thanks for the replies thus far!
@ Karl: it's a 2GB SD card so plenty of space left (1.5GB or thereabouts). I think the GIMP install was a .sfs.
Originally I tried to use a savefile but had the issue that it wouldn't get read upon a reboot...so all the settings I had changed were lost - so I used the option to save to the SD card directly instead (that worked). Wasn't aware that the savefile is not ext3 even though that's what I'm using as the filesystem?
I will try to get the output you requested...might be a day or two though.
Uebrigens: Deutsch geht auch wenn's dir lieber ist!
Thanks all,
Bernie