Puppy does not boot with soundcard config saved before?
Posted: Sat 08 Mar 2008, 14:29
Hello,
I'm running Puppy 3.01. My notebook has an on-board soundchip, but I prefer my external USB-soundcard. After the frugal installation of puppy the on-board soubdchip was configured by default. So I used ALSAconfig to set up my external USB-soundcard. Having done this successfully I checked the etc/modprobe.conf . The final and relevant lines are as follows.
# --- BEGIN: Generated by ALSACONF, do not edit. ---
# --- ALSACONF verion 1.0.8 ---
alias snd-card-0 snd-usb-audio
alias sound-slot-0 snd-usb-audio
# --- END: Generated by ALSACONF, do not edit. ---
Having saved the settings in the pup_save-301.2fx I did a reboot:
But Puppy does not configure my USB-soundcard but the on-board soundchip. Astonished by this I checked the etc/modeprobe.conf again.
Here are the final and relevant lines:
# --- BEGIN: Generated by ALSACONF, do not edit. ---
# --- ALSACONF verion 1.0.8 ---
alias sound-slot-0 snd-usb-audio
# --- END: Generated by ALSACONF, do not edit. ---
alias snd-card-0 snd-via82xx
alias sound-slot-0 snd-via82xx
What am I doing wrong? Why doesn't Puppy configure my USB-soundcard when booting? What can I do to use my USB-soundcard by default?
I'm running Puppy 3.01. My notebook has an on-board soundchip, but I prefer my external USB-soundcard. After the frugal installation of puppy the on-board soubdchip was configured by default. So I used ALSAconfig to set up my external USB-soundcard. Having done this successfully I checked the etc/modprobe.conf . The final and relevant lines are as follows.
# --- BEGIN: Generated by ALSACONF, do not edit. ---
# --- ALSACONF verion 1.0.8 ---
alias snd-card-0 snd-usb-audio
alias sound-slot-0 snd-usb-audio
# --- END: Generated by ALSACONF, do not edit. ---
Having saved the settings in the pup_save-301.2fx I did a reboot:
But Puppy does not configure my USB-soundcard but the on-board soundchip. Astonished by this I checked the etc/modeprobe.conf again.
Here are the final and relevant lines:
# --- BEGIN: Generated by ALSACONF, do not edit. ---
# --- ALSACONF verion 1.0.8 ---
alias sound-slot-0 snd-usb-audio
# --- END: Generated by ALSACONF, do not edit. ---
alias snd-card-0 snd-via82xx
alias sound-slot-0 snd-via82xx
What am I doing wrong? Why doesn't Puppy configure my USB-soundcard when booting? What can I do to use my USB-soundcard by default?