Installing the Bewan Wi-Fi usb54 adapter on Puppy 301
Posted: Sun 09 Dec 2007, 17:47
Hi,
Introduction
I am experiencing difficulties to make my wireless adapter working and there is nothing about Bewan manufacturer on this forum.
I should be able to reproduce any single action needed to make this working and as I am new to Linux I need somewhere where I can write them down.
That's why I create this topic.
Any help appreciated, so that I can update this "How-To" with an Happy end.
I will use an high detail level so that even a child could follow me.
Configuration
--wifi adapter : Bewan Wi-Fi usb54
--processor : intel pentium III 450mhz
--ram : 320MB
--hard disk drive : no
--puppy version : 3.01-seamonkey
--distant modem router connected to Internet : Bewan 700G ADSL2+
---dhcp : off
---routeur ip : 192.168.0.1
---ESSID : FINWIFI (not hidden)
---channel : 11
---security : open
Starting
--adapter connected to an usb port, Puppy's CD into cd-rom drive
--Power On !
--select Fr (nobody's perfect) and press Enter
--press Enter to confirm Xorg selection
--press Enter to confirm 1024x768x16 video resolution
--click Connect icon
--click the icon near Connect to internet by network interface
--see that there is something in Interfaces part and click rausb0
--click Wireless button
--click Ok to confirm the following message :
Note: The interface you have selected uses the module rt2570, which does not support WPA encryption
--configure like this:
Profile Name: MyProfileName
ESSID : FINWIFI
--click Use This Profile
--wait for saving profile to close Will never do
Leaving
--menu, shuhtdown, power-off computer
--select do not save and press Enter
Please help me to go further.
a+,=)
-=Finiderire=-
Introduction
I am experiencing difficulties to make my wireless adapter working and there is nothing about Bewan manufacturer on this forum.
I should be able to reproduce any single action needed to make this working and as I am new to Linux I need somewhere where I can write them down.
That's why I create this topic.
Any help appreciated, so that I can update this "How-To" with an Happy end.
I will use an high detail level so that even a child could follow me.
Configuration
--wifi adapter : Bewan Wi-Fi usb54
--processor : intel pentium III 450mhz
--ram : 320MB
--hard disk drive : no
--puppy version : 3.01-seamonkey
--distant modem router connected to Internet : Bewan 700G ADSL2+
---dhcp : off
---routeur ip : 192.168.0.1
---ESSID : FINWIFI (not hidden)
---channel : 11
---security : open
Starting
--adapter connected to an usb port, Puppy's CD into cd-rom drive
--Power On !
--select Fr (nobody's perfect) and press Enter
--press Enter to confirm Xorg selection
--press Enter to confirm 1024x768x16 video resolution
--click Connect icon
--click the icon near Connect to internet by network interface
--see that there is something in Interfaces part and click rausb0
--click Wireless button
--click Ok to confirm the following message :
Note: The interface you have selected uses the module rt2570, which does not support WPA encryption
--configure like this:
Profile Name: MyProfileName
ESSID : FINWIFI
--click Use This Profile
--wait for saving profile to close Will never do
Leaving
--menu, shuhtdown, power-off computer
--select do not save and press Enter
Please help me to go further.
a+,=)
-=Finiderire=-