Puppy Linux Discussion Forum Forum Index Puppy Linux Discussion Forum
Puppy HOME page : puppylinux.com
"THE" alternative forum : puppylinux.info
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

The time now is Wed 17 Dec 2014, 21:15
All times are UTC - 4
 Forum index » Advanced Topics » Hardware » Networking » Wireless
SMC USB Adapter (SMCWUSBT-G-CA)
Post_new_topic   Reply_to_topic View_previous_topic :: View_next_topic
Page 1 of 1 Posts_count_1  
Author Message
fasteddy

Joined: 05 Nov 2007
Posts: 1

PostPosted: Mon 05 Nov 2007, 13:27    Post_subject:  SMC USB Adapter (SMCWUSBT-G-CA)
Sub_title: Need to unplug/plug adapter each boot, then setup wireless config
 

I have a SMCWUSBT-G-CA wireless usb adapter. I can get it to work using ndiswrapper, though it's a little trickier than most. It requires 2 drivers to be loaded, net5523.inf and athfmwdl.inf. After these are loaded, I have to physically unplug, then plug in the adapter. Then I can proceed to set up my wireless connection.
However, when I reset the computer (btw, I'm using a full install of puppy to hda1) I have to go through all this again. As far as I can tell, I'm hitting "save" everywhere that it's an option, but still no go. This is something of a pain to go through every time I boot up...
Back to top
View user's profile Send_private_message 
Display_posts:   Sort by:   
Page 1 of 1 Posts_count_1  
Post_new_topic   Reply_to_topic View_previous_topic :: View_next_topic
 Forum index » Advanced Topics » Hardware » Networking » Wireless
Jump to:  

Rules_post_cannot
Rules_reply_cannot
Rules_edit_cannot
Rules_delete_cannot
Rules_vote_cannot
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group
[ Time: 0.0330s ][ Queries: 11 (0.0034s) ][ GZIP on ]