2.17 livecd and wrong wireless driver
Posted: Sat 21 Jul 2007, 17:56
When 2.17 boots it finds my usb wireless adapter. It is an Airlink usb wireless adapter that uses a zd1215 chipset that does not work with the zd1211rw driver that is installed on boot. It requires a window driver uses a modified driver zd1211bu.inf
Using the zd12rw driver makes the adapter show up as eth2. In 2.16, after ndiswrapper with the zd1211bu.inf driver it shows up properly as wlan0.
I have in the terminal done modprobe -r zd1211rw
Then clicking on connect, I go to load driver, ndiswrapper, and location of the driver. It loads the driver, says ndiswrapper is loaded, and wlan0 shows up in the connect box. After scanning, and selecting my network, the mouse slows and works sporactically and will not connect.
How do I stop the livecd from installing the wrong driver(if that's what I have to do) or what are the steps I need to take to make my wireless adapter and mouse work. 2.16 doesn't give me any problems. It does not load the zs1211rw driver and ndiswrapper, connect, and the network is fine.
NOTE: on further exploring, if I plug the unit in and use ndiswrapper it does the samething - the small box on the bottom right starts showing cpu usage(very high) and locks the mouse ect. If I use the terminal and ndiswrapper along with -m and modprobe, it does the same thing. This driver works perfect in 2.16.
What's the difference between 2.16 and 2.17 when it comes to wirless networking?
Using the zd12rw driver makes the adapter show up as eth2. In 2.16, after ndiswrapper with the zd1211bu.inf driver it shows up properly as wlan0.
I have in the terminal done modprobe -r zd1211rw
Then clicking on connect, I go to load driver, ndiswrapper, and location of the driver. It loads the driver, says ndiswrapper is loaded, and wlan0 shows up in the connect box. After scanning, and selecting my network, the mouse slows and works sporactically and will not connect.
How do I stop the livecd from installing the wrong driver(if that's what I have to do) or what are the steps I need to take to make my wireless adapter and mouse work. 2.16 doesn't give me any problems. It does not load the zs1211rw driver and ndiswrapper, connect, and the network is fine.
NOTE: on further exploring, if I plug the unit in and use ndiswrapper it does the samething - the small box on the bottom right starts showing cpu usage(very high) and locks the mouse ect. If I use the terminal and ndiswrapper along with -m and modprobe, it does the same thing. This driver works perfect in 2.16.
What's the difference between 2.16 and 2.17 when it comes to wirless networking?