Trying Puppy again. This time using 2.15CE in fresh install. Never could get wireless to work in 2.14. Probably doing something wrong. Download PET firmware fix for bcm43xx, but still no joy.
What do I need in 2.15CE to get get wireless to work on my Fujitsu laptop using Broadcom bcm4306. Want to use WPA-PSK/TKIP. Wired connection works fine.
donde
bcm43xx and 2.15CE
-
- Posts: 5464
- Joined: Fri 10 Jun 2005, 05:12
- Location: Australia
I just made a post about obtaining the correct bcm43xx firmware here -
http://www.murga-linux.com/puppy/viewto ... 546#115546
http://www.murga-linux.com/puppy/viewto ... 546#115546
bcm43xx and 2.15CE
I found both the sys and the inf files in C:\drivers\WLAN\broadcom. I'll proceed as you say in your message. Is there any other .pet I should install? I think at one time I tried bcm43xx-firmware.pet which didn't work. Also, what is net-setup-2.15.pet?
Thanks again
donde
Thanks again
donde
Re: bcm43xx and 2.15CE
That is the updated network detection wizard for Puppy 2.15CE-R2 and you should download and install the version HERE if you are having network detection problems.donde wrote:Also, what is net-setup-2.15.pet?
Hope that helps.
[i]Actions speak louder than words ... and they usually work when words don't![/i]
SIP:whodo@proxy01.sipphone.com; whodo@realsip.com
SIP:whodo@proxy01.sipphone.com; whodo@realsip.com