Page 1 of 1
Installing bionic pup 64 on Linux lite 5.0
Posted: Thu 18 Jun 2020, 19:38
by Maulers
Hello everyone I have a Fujitsu tablet on which I have installed Linux lite 5.0. I ran puppy Linux on my Windows machine under virtualbox and quite enjoyed it. I want to install bionic pup 64 instead of LL5 and made a etcher iso and changed the boot sequence. Unfortunately no luck installing it. Can anyone suggest a solution pls? Thanks. Maulers
Posted: Thu 18 Jun 2020, 20:15
by bigpup
and made a etcher iso
what does that say?
You used Etcher to make a live install of Bionicpup64 8.0 on a USB flash drive or SD card???
Tried to boot with it???
changed the boot sequence. Unfortunately no luck installing it
The USB drive or SD card will not boot???
It boots, but you can not install to the internal drive?????
Do you only want Bionicpup64 8.0 on the internal drive???
I assume the internal drive is a emmc drive?
Posted: Fri 19 Jun 2020, 19:57
by Maulers
Dear everyone thank you very much for the replies I will try the yaip tomorrow. Thanks. Maulers.