Wireless network connection
Posted: Sat 17 Aug 2013, 18:31
Live CD with save file on hard drive.
Netgear n300 USB wireless network adapter.
When I boot up, my network adapter is not working or even turned on.
I can use Network Wizard to set it up, using Ndiswrapper, and a Windows driver. It is activated and works now.
I save this setup, but on reboot, adapter is not working or even turned on.
Rerun Network Wizard, setup, and connection works. The profile is saved, but I have to select it and run setup at each boot.
So, I tried using Frisbee.
Setup connection.
Rebooted.
Network adapter active and connection working.
With Frisbee, the settings were saved and used at next bootup.
At bootup, there are Frisbee messages about eth0 and wlan0 shutdown. It then activates wlan0 and connection working.
I have tried to find this, but I seem to remember Barry stating (in his blog) something about having Wlan turned off when he was making changes to the startup scripts.
Netgear n300 USB wireless network adapter.
When I boot up, my network adapter is not working or even turned on.
I can use Network Wizard to set it up, using Ndiswrapper, and a Windows driver. It is activated and works now.
I save this setup, but on reboot, adapter is not working or even turned on.
Rerun Network Wizard, setup, and connection works. The profile is saved, but I have to select it and run setup at each boot.
So, I tried using Frisbee.
Setup connection.
Rebooted.
Network adapter active and connection working.
With Frisbee, the settings were saved and used at next bootup.
At bootup, there are Frisbee messages about eth0 and wlan0 shutdown. It then activates wlan0 and connection working.
I have tried to find this, but I seem to remember Barry stating (in his blog) something about having Wlan turned off when he was making changes to the startup scripts.