Page 2 of 2
Posted: Mon 30 Mar 2015, 22:10
by ardvark
Hi guys...
Yes, I installed the driver (using another adapter) while I was still using 6.0, however, during the session, I upgraded to 6.0.2 but was told I needed to reboot for all the changes made to take affect. So, I'm gathering for this to work, I would need to install Tahr to the hard drive.
Regards...
Posted: Tue 31 Mar 2015, 02:07
by tempestuous
ardvark wrote:I'm gathering for this to work, I would need to install Tahr to the hard drive.
Well, not necessarily a
full hard drive installation, but the minimum requirement would be a (reasonably large) savefile, and you would certainly need a reboot so that this savefile is then in use, most critically including the revised kernel.
If you're wanting to test this wifi driver in a live-CD environment, it would a whole lot easier if you just get the tahr-6.0.2_PAE.iso
and boot to that.
Posted: Tue 31 Mar 2015, 02:36
by ardvark
tempestuous wrote:If you're wanting to test this wifi driver in a live-CD environment, it would a whole lot easier if you just get the tahr-6.0.2_PAE.iso and boot to that.
I agree completely and, Lord willing, will try that as soon as possible.
I'm going to mark this thread as "ON HOLD" until I'm able to purchase some CD-R's and burn a copy of 6.0.2. Then I can report back with any findings.
Thanks again!