Posted: Sat 20 Apr 2013, 19:21 Post subject:
Is there a way to force X to start at 1920x1080?
Using Puppy precise 5.5
I have a 1920x1080 HDTV which I can connect to my PC through the VGA connector. If I boot with the TV then X starts at 1024x768. If I start xorgwizard then it says the TV can not be scanned and asks me to choose a resolution but then starts at 1024x768 whatever I choose.
The TV's manual says to set the resolution on the PC before connecting to the TV. I can set 1440x900 (the maximum on my old monitor) and that's usable on the TV but it's the wrong ratio. If I restart X then it reverts to 1024x768. If I manually change the resolution in xorg.conf to 1920x1080 (or anything else) then X starts at 1024x768 and sometimes changes the value in xorg.conf!
Is there a way to force X to start at 1920x1080? The TV's manual lists supported resolutions but for the frequency it gives only 60Hz sometimes followed by A or B. What would I set for the frequencies for X? Last edited by zygo on Sat 27 Apr 2013, 09:39; edited 1 time in total
Joined: 20 Jun 2010 Posts: 3982 Location: Kiel,Germany
Posted: Sun 21 Apr 2013, 11:47 Post subject:
I have a newer nvidia pci-express card with DVI , HDMI and VGA out .
Have not had the chance to attach any HDMI screen .
What i know is that with the default kernel and xorg drivers the ddcprobe command only works on the
lowest out ( DVI ) in my case . ddcprobe scans for possible resolutions, and these are offered in xorgwizard .
I don't know anything about RGB out .
My older 1280x1024 monitor needed to press a button to switch VGA and DVI . DVI is not worth it in my experience .
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You can download files in this forum