---
I have been working towards getting Frisbee working on Archpup
1. Hardware
Im using the Broadcom Corporation BCM4318 [AirForce One 54g]
No frisbee/network-wizard to find and load the correct module - found it is b43
Added
Code: Select all
modprobe b43
however, b43 firmware isn't included in Archpup or archpup-firmware.sfs
So copied /lib/firmware/b43 from Slacko
the following code now shows work wlan0 connection-
Code: Select all
ifconfig wlan0 up
ifconfig
2. Software-
Archpup doesn't use PETs by default, so I converted Frisbee-beta2.4-spup.pet to SFS
Only trouble with going from PET -> SFS is that un/install scripts pinstall.sh and puninstall.sh aren't run (as far as i know).
Ran pinstall.sh and then loaded Frisbee-beta2.4-spup.sfs
Archpup doesn't seem to run things in the /root/Startup directory at startup. Add
Code: Select all
exec /root/Startup/frisbee-tray
i've uploaded Frisbee-beta2.4-spup.sfs and its pinstall.sh here-
http://www.meownplanet.net/puppylinuxst ... _5.3.1.sfs
http://www.meownplanet.net/puppylinuxst ... install.sh
---
3. Bodging-
Not all the functions seem to work correctly in Frisbee. Clicking 'Create Profile...' doesn't do anything. Manually edited /usr/local/Frisbee/wpa_supplicant.conf for network key. Copy from working Frisbee installation if your unsure.
Code: Select all
ctrl_interface=/var/run/wpa_supplicant
ap_scan=2
update_config=1
network={
ssid="12345678"
scan_ssid=1
psk="YOURPASSWD"
proto=WPA
key_mgmt=WPA-PSK
pairwise=TKIP
group=TKIP WEP104 WEP40
}
frisbee-tray > Setup Networking > wireless network reset
and waiting a few seconds ; -)