Guvcview 1.6.1

Requests go here. If you fill a request, give it a new thread in the appropriate category and then link to it in the request thread.
Post Reply
Message
Author
User avatar
walter leonardo
Posts: 234
Joined: Thu 10 Dec 2009, 22:10

Guvcview 1.6.1

#1 Post by walter leonardo »

Hello someone can compile guvcview-1.6.1 for Wary 5.3? :D

User avatar
rcrsn51
Posts: 13096
Joined: Tue 05 Sep 2006, 13:50
Location: Stratford, Ontario

Re: Guvcview 1.6.1

#2 Post by rcrsn51 »

walter leonardo wrote:Hello someone can compile guvcview-1.6.1 for Wary 5.3? :D
Are you aware of guvcview-1.5.0 here? There are significant problems with building guvcview in older Puppies past this point.

User avatar
walter leonardo
Posts: 234
Joined: Thu 10 Dec 2009, 22:10

#3 Post by walter leonardo »

I did not know, thanks and sorry. :roll:

User avatar
walter leonardo
Posts: 234
Joined: Thu 10 Dec 2009, 22:10

#4 Post by walter leonardo »

report error in wary 5.3.90
Attachments
cap.jpg
(139.4 KiB) Downloaded 856 times

User avatar
rcrsn51
Posts: 13096
Joined: Tue 05 Sep 2006, 13:50
Location: Stratford, Ontario

#5 Post by rcrsn51 »

Did you install both packages? I tested it in Wary 5.3 with two different webcams and guvcview worked. But it may not be compatible with all devices.

I did not test it in 5.3.90.

[Edit] I checked in Wary 5.3.90 and guvcview worked there too. Try the following command. Does it wake up your webcam?

Code: Select all

mplayer tv://

User avatar
walter leonardo
Posts: 234
Joined: Thu 10 Dec 2009, 22:10

#6 Post by walter leonardo »

If you install the two packages. Now if I work well, but some programs like Mplayer and Ogle DVD not working. It will be up to check the dependencies. Thank you!!! :wink:

hikohan
Posts: 32
Joined: Tue 29 Nov 2011, 05:42

tested in RACY 5.3.90

#7 Post by hikohan »

Test report in RACY 5.3.90 .

works great!! after both packages install, run gucview and video/image capture smoothly.

Thanks for your help!!

hikohan
Posts: 32
Joined: Tue 29 Nov 2011, 05:42

1.5.0 not works in Precise 5.4.3

#8 Post by hikohan »

error message as follow:

"guvcview doesn't start: Fatal: g_thread NOT supported"

seems need to upgrade Guvcview 1.5.3 later.

User avatar
mister_electronico
Posts: 969
Joined: Sun 20 Jan 2008, 20:20
Location: Asturias_ España
Contact:

I have the same problem

#9 Post by mister_electronico »

hikohan yes I have the same problem. I think maybe the incompatibility with GTK.

I am working with slacko 5.4 no precise.

But when I run command:

mplayer tv:// -tv driver=v4l2:width=768:height=450:device=/dev/video0 -fps 3

work ok.

Someone can give us any help.

Thanks.

Post Reply