I wonder if something else is going on. You're not giving me much detail to help you with. So the network wizard found the card, correct? The GUI should show what driver it's using, can you let me know? Ideally you should start from scratch by deleting the save file from the USB stick so you can give me the answer to these questions in terms of a fresh install vs. reboots.multiblitz wrote:...I did already exactly what you suggested, it will than find the connect in the mpdwizard....but forgets everything after the re-boot.
How exactly are you rebooting? The network wizard should save a file at /etc/network-wizard/network/interfaces/<mac address>.conf, where <mac address> is your actual mac address. When you reboot can you check to see that this file exists? Also cat the file and let me know what it's contents are.
After rebooting does the network wizard still see the card? Is the driver still the same as it was from the first boot? If you re-configure from the wizard can it still connect?
The output of this file (AFTER the first reboot) would be helpful too
Code: Select all
cat /etc/rc.d/PUPSTATE