pemasu,pemasu wrote:Geoffrey. I dont see anything wrong with this information.[ 5.369145] b43-pci-bridge 0000:04:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[ 5.369161] b43-pci-bridge 0000:04:00.0: setting latency timer to 64
[ 5.383585] ssb: Core 0 found: ChipCommon (cc 0x800, rev 0x16, vendor 0x4243)
[ 5.383603] ssb: Core 1 found: IEEE 802.11 (cc 0x812, rev 0x0F, vendor 0x4243)
[ 5.383620] ssb: Core 2 found: PCMCIA (cc 0x80D, rev 0x0A, vendor 0x4243)
[ 5.383638] ssb: Core 3 found: PCI-E (cc 0x820, rev 0x09, vendor 0x4243)
[ 5.436908] ssb: Sonics Silicon Backplane found on PCI device 0000:04:00.0
[ 28.227073] b43-phy0: Broadcom 4312 WLAN found (core revision 15)
[ 28.335407] ieee80211 phy0: Selected rate control algorithm 'minstrel_ht'
[ 28.335597] Registered led device: b43-phy0::tx
[ 28.335614] Registered led device: b43-phy0::rx
[ 28.335630] Registered led device: b43-phy0::radio
[ 28.335645] Broadcom 43xx driver loaded [ Features: PMNLS ]
[ 41.026901] b43-phy0: Loading firmware version 666.2 (2011-02-23 01:15:07)
Saluki uses b43 firmwares for kernels above 3.2.0. There is now much more of them. But I cant see error with loading it.
Ok, it did say it wasn't loaded after I made a save file and rebooted, I tried reloading it but it just don't work, strange that it works with 0.13 every time yet only with 0.14 on first boot before making a save.
I'll see if I can use a 0.13 save and let it update with 0.14 to see if it keeps it settings, I don't know what else to try, I've been through this three times to check and get the same result every time.
I'll try it on one of the other laptops to be sure that it isn't a hardware fault, but I'm guessing the result will be identical.