915resolution patched

For drivers and kernel modules.
Message
Author
tempestuous
Posts: 5464
Joined: Fri 10 Jun 2005, 05:12
Location: Australia

#41 Post by tempestuous »

915resolution just updated in the first post to support the HD Graphics 3000 device, device ID 0104:8086
as found in (some) Core i3/i5/i7 "Sandy Bridge" integrated processors.

zubr
Posts: 4
Joined: Wed 15 Jun 2011, 16:13

#42 Post by zubr »

az@az:~# 915resolution -l
Intel 800/900 Series VBIOS Hack : version 0.5.3

Unable to determine bios type.
Please run the program 'dump_bios' as root and
email the file 'vbios.dmp' to stomljen@yahoo.com.
Chipset: HD3000
Mode Table Offset: $C0000 + $142
Mode Table Entries: 39

tempestuous
Posts: 5464
Joined: Fri 10 Jun 2005, 05:12
Location: Australia

#43 Post by tempestuous »

zubr wrote:Please run the program 'dump_bios' as root and
email the file 'vbios.dmp' to stomljen@yahoo.com.
That's probably what you will have to do. My package includes the "dump_bios" utility.

... or maybe upgrade to the very latest Xorg with updated intel driver.

zubr
Posts: 4
Joined: Wed 15 Jun 2011, 16:13

#44 Post by zubr »

Bios attached.

I use latest Xorg, but I cannot use Intel driver because after 2.9 version it works only with KMS, but FreeBSD still has no KMS support. Drivers before 2.9 version don't have support for Sandy. :(

So I have resolution 1024x768 instead of 1366x768 with VESA.. :(
Attachments
vbios.dmp.bz2
HD3000 dump
(38.38 KiB) Downloaded 1241 times

haohetao
Posts: 3
Joined: Fri 26 Nov 2010, 04:12

#45 Post by haohetao »

My Computer
zotac H55ITX-A-E Wifi
intel core i3 530(2.66GHz)
HD Intel® HD Graphics (used in Intel® 2010 Core™ i7/i5/i3 processor family)

915resolution -l
Intel 800/900 Series VBIOS Hack : version 0.5.3

Intel chipset detected. However, 915resolution was unable to determine the chipset type.
Chipset Id: 408086
Please report this problem to stomljen@yahoo.com
lspci -mm -v -d 8086:0042
Slot: 00:02.0
Class: VGA compatible controller
Vendor: Intel Corporation
Device: Core Processor Integrated Graphics Controller
SVendor: Intel Corporation
SDevice: Core Processor Integrated Graphics Controller
Rev: 12
lspci -nn -vv -d 8086:0042
00:02.0 VGA compatible controller [0300]: Intel Corporation Core Processor Integrated Graphics Controller [8086:0042] (rev 12) (prog-if 00 [VGA controller])
Subsystem: Intel Corporation Core Processor Integrated Graphics Controller [8086:0042]
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx+
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0
Interrupt: pin A routed to IRQ 44
Region 0: Memory at fb800000 (64-bit, non-prefetchable) [size=4M]
Region 2: Memory at d0000000 (64-bit, prefetchable) [size=256M]
Region 4: I/O ports at dc00
Expansion ROM at <unassigned> [disabled]
Capabilities: [90] MSI: Enable+ Count=1/1 Maskable- 64bit-
Address: fee0500c Data: 4189
Capabilities: [d0] Power Management version 2
Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME-
Capabilities: [a4] PCI Advanced Features
AFCap: TP+ FLR+
AFCtrl: FLR-
AFStatus: TP-
Kernel driver in use: i915
Kernel modules: i915

haohetao
Posts: 3
Joined: Fri 26 Nov 2010, 04:12

#46 Post by haohetao »

Hi,Why not have my graphics

tempestuous
Posts: 5464
Joined: Fri 10 Jun 2005, 05:12
Location: Australia

#47 Post by tempestuous »

haohetao, check your private messages!
7 days ago (July 20) I sent you an updated version of 915resolution to test.

Samuel_Vimes
Posts: 1
Joined: Thu 28 Jul 2011, 14:05

#48 Post by Samuel_Vimes »

I have the same problem with my dell inpiron N5110 =(

sudo ./915resolution -l
Intel 800/900 Series VBIOS Hack : version 0.5.3

Intel chipset detected. However, 915resolution was unable to determine the chipset type.
Chipset Id: 1048086
Please report this problem to stomljen@yahoo.com
lspci -mm -v -d 8086:0116
Slot: 00:02.0
Class: VGA compatible controller
Vendor: Intel Corporation
Device: Sandy Bridge Integrated Graphics Controller
SVendor: Dell
SDevice: Device 04ca
Rev: 09
lspci -nn -vv -d 8086:0116
00:02.0 VGA compatible controller [0300]: Intel Corporation Sandy Bridge Integrated Graphics Controller [8086:0116] (rev 09) (prog-if 00 [VGA controller])
Subsystem: Dell Device [1028:04ca]
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0
Interrupt: pin A routed to IRQ 11
Region 0: Memory at f6400000 (64-bit, non-prefetchable) [size=4M]
Region 2: Memory at d0000000 (64-bit, prefetchable) [size=256M]
Region 4: I/O ports at f000
Expansion ROM at <unassigned> [disabled]
Capabilities: [90] MSI: Enable- Count=1/1 Maskable- 64bit-
Address: 00000000 Data: 0000
Capabilities: [d0] Power Management version 2
Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME-
Capabilities: [a4] PCI Advanced Features
AFCap: TP+ FLR+
AFCtrl: FLR-
AFStatus: TP-

rbeef
Posts: 1
Joined: Wed 06 Jun 2012, 15:19

#49 Post by rbeef »

I have a new Acer 4752-6431. I'm getting the following:

slippy$ sudo ./915resolution -l
Password:
Intel 800/900 Series VBIOS Hack : version 0.5.3

Unable to determine bios type.
Please run the program 'dump_bios' as root and
email the file 'vbios.dmp' to stomljen@yahoo.com.
Chipset: HD3000
Mode Table Offset: $C0000 + $142
Mode Table Entries: 39
slippy$

It sees the chipset but not the VBIOS. Can you help? I've uploaded my vbios.dmp file.

User avatar
vtpup
Posts: 1420
Joined: Thu 16 Oct 2008, 01:42
Location: Republic of Vermont
Contact:

#50 Post by vtpup »

Same problem here. I ran the 915 resolution patch .pet but got same result.
Error message below appears every boot. Racy 5.3 on an Acer Aspire 5349-2635 laptop)

Code: Select all

# 915resolution -l
Intel 800/900 Series VBIOS Hack : version 0.5.3

Unable to determine bios type.
Please run the program 'dump_bios' as root and
email the file 'vbios.dmp' to stomljen@yahoo.com.
Chipset: HD3000
Mode Table Offset: $C0000 + $142
Mode Table Entries: 39

# lspci
00:00.0 Host bridge: Intel Corporation 2nd Generation Core Processor Family DRAM Controller (rev 09)
00:02.0 VGA compatible controller: Intel Corporation 2nd Generation Core Processor Family Integrated Graphics Controller (rev 09)
The display is working, I don't know if the above error message ("Unable to......39") is significant, but is always appears on startup.
[color=darkblue]Acer Aspire 5349-2635 laptop Tahrpup.[/color]
[color=blue]Acer R11 and C720 Chromebks Bionicpup64[/color]
[color=olive]Acer Iconia A1-830 tablet no pup[/color]
[color=orange]www.sredmond.com[/color]

User avatar
01micko
Posts: 8741
Joined: Sat 11 Oct 2008, 13:39
Location: qld
Contact:

#51 Post by 01micko »

Newer xorgs, such as in Racy/Slacko/Dpup/Precise seem not to need 915resolution. I tried in Slacko development and I get nice widescreen on my laptops that have it including a small eee-701SD.
Puppy Linux Blog - contact me for access

User avatar
vtpup
Posts: 1420
Joined: Thu 16 Oct 2008, 01:42
Location: Republic of Vermont
Contact:

#52 Post by vtpup »

I won't worry about the message, then. Thanks 01 micko.
[color=darkblue]Acer Aspire 5349-2635 laptop Tahrpup.[/color]
[color=blue]Acer R11 and C720 Chromebks Bionicpup64[/color]
[color=olive]Acer Iconia A1-830 tablet no pup[/color]
[color=orange]www.sredmond.com[/color]

frontman
Posts: 1
Joined: Fri 22 Feb 2013, 03:56

#53 Post by frontman »

Can someone host the patch? The download links aren't working for me.

User avatar
Semme
Posts: 8399
Joined: Sun 07 Aug 2011, 20:07
Location: World_Hub

#54 Post by Semme »

Not werk'in? Plug'm with wget..

User avatar
01micko
Posts: 8741
Joined: Sat 11 Oct 2008, 13:39
Location: qld
Contact:

#55 Post by 01micko »

You mean the patched source? At Barry's source repo

http://bkhome.org/sources/alphabetical/ ... 617.tar.gz

You need the secret password :wink: (not so secret, look around)
Puppy Linux Blog - contact me for access

darwinev0lved
Posts: 83
Joined: Tue 29 Jul 2008, 12:19

#56 Post by darwinev0lved »

01micko wrote:Newer xorgs, such as in Racy/Slacko/Dpup/Precise seem not to need 915resolution. I tried in Slacko development and I get nice widescreen on my laptops that have it including a small eee-701SD.
what precisely are you / were you using ? I was trying to resurrect my eee-701 and have tried precise 5.5 and slacko 5.5 and in neither of them was I able to get the 800*480 resolution.

Also the download links to the pets are broken / dead - does anybody have working links ?

Regards,
Jon.

User avatar
ally
Posts: 1957
Joined: Sat 19 May 2012, 19:29
Location: lincoln, uk
Contact:

#57 Post by ally »

hey darwin

there is an eee specific build which has everything working

puppeee1.0 available here: http://distro.ibiblio.org/puppylinux/Pu ... uppeee1.0/

just need to select correct one for processor

:)

darwinev0lved
Posts: 83
Joined: Tue 29 Jul 2008, 12:19

#58 Post by darwinev0lved »

ally wrote:hey darwin

there is an eee specific build which has everything working

puppeee1.0 available here: http://distro.ibiblio.org/puppylinux/Pu ... uppeee1.0/

just need to select correct one for processor

:)
thanks for the link Ally - I've actually got a version, I think it's Lucid 4.2 installed that works fine - I just fancied trying to update to see what the latest and greatest were like ... and actually I have success (Precise 5.5) - had to manually enter in the vertical & horizontal 30.61 & 60.61 and it came back with the 800*480 resolution. So all is fine - will see what else I can do with it. All is happy in eee-puppy land (till the next gotcha)

thanks again

J

Post Reply