Puppy Linux Discussion Forum

[puffan]

Hi,

at first: thank you for this fast, nice and very good op sys.

I were able to install it to my old computers, and I were able to see that they are fast!

I have a problem with my network card, Accton2242 (Puppy 3.01).

--------------------------- log from boot -------------------------------------
syslog.info syslogd started: BusyBox v1.6.1
kern.notice kernel: klogd started: BusyBox v1.6.1 (2007-08-26 04:52:27 MDT)
kern.notice kernel: Linux version 2.6.18.1 (root@puppypc) (gcc version 3.4.4) #1 Thu Apr 19 07:47:47 PUP 2007
kern.info kernel: BIOS-provided physical RAM map:
kern.warn kernel: BIOS-e820: 0000000000000000 - 000000000009f800 (usable)
kern.warn kernel: BIOS-e820: 000000000009f800 - 00000000000a0000 (reserved)
kern.warn kernel: BIOS-e820: 00000000000eb000 - 0000000000100000 (reserved)
kern.warn kernel: BIOS-e820: 0000000000100000 - 000000001eff0000 (usable)
kern.warn kernel: BIOS-e820: 000000001eff0000 - 000000001efffc00 (ACPI data)
kern.warn kernel: BIOS-e820: 000000001efffc00 - 000000001f000000 (ACPI NVS)
kern.warn kernel: BIOS-e820: 00000000fffe0000 - 0000000100000000 (reserved)
kern.notice kernel: 0MB HIGHMEM available.
kern.notice kernel: 495MB LOWMEM available.
kern.debug kernel: On node 0 totalpages: 126960
kern.debug kernel: DMA zone: 4096 pages, LIFO batch:0
kern.debug kernel: Normal zone: 122864 pages, LIFO batch:31
kern.info kernel: DMI 2.3 present.
kern.debug kernel: ACPI: RSDP (v000 PTLTD ) @ 0x000f7030
kern.debug kernel: ACPI: RSDT (v001 PTLTD RSDT 0x06040000 LTP 0x00000000) @ 0x1effba62
kern.debug kernel: ACPI: FADT (v001 VT8603 TWISTER 0x06040000 PTL 0x000f4240) @ 0x1efffb64
kern.debug kernel: ACPI: BOOT (v001 PTLTD $SBFTBL$ 0x06040000 LTP 0x00000001) @ 0x1efffbd8
kern.debug kernel: ACPI: DSDT (v001 VIA PTL_ACPI 0x06040000 MSFT 0x0100000b) @ 0x00000000
kern.err kernel: ACPI: BIOS age (2001) fails cutoff (2002), acpi=force is required to enable ACPI
kern.warn kernel: ACPI: Disabling ACPI support
kern.warn kernel: Allocating PCI resources starting at 20000000 (gap: 1f000000:e0fe0000)
kern.warn kernel: Detected 1100.073 MHz processor.
kern.warn kernel: Built 1 zonelists. Total pages: 126960
kern.notice kernel: Kernel command line: initrd=initrd.gz pmedia=cd layerfs=aufs BOOT_IMAGE=vmlinuz
kern.info kernel: Enabling fast FPU save and restore... done.
kern.info kernel: Enabling unmasked SIMD FPU exception support... done.
kern.info kernel: Initializing CPU#0
kern.warn kernel: PID hash table entries: 2048 (order: 11, 8192 bytes)
kern.warn kernel: Console: colour VGA+ 80x25
kern.warn kernel: Dentry cache hash table entries: 65536 (order: 6, 262144 bytes)
kern.warn kernel: Inode-cache hash table entries: 32768 (order: 5, 131072 bytes)
kern.info kernel: Memory: 498040k/507840k available (2414k kernel code, 9164k reserved, 797k data, 176k init, 0k highmem)
kern.warn kernel: Checking if this processor honours the WP bit even in supervisor mode... Ok.
kern.warn kernel: Calibrating delay using timer specific routine.. 2201.62 BogoMIPS (lpj=11008134)
kern.warn kernel: Mount-cache hash table entries: 512
kern.debug kernel: CPU: After generic identify, caps: 0387f9ff 00000000 00000000 00000000 00000000 00000000 00000000
kern.debug kernel: CPU: After vendor identify, caps: 0387f9ff 00000000 00000000 00000000 00000000 00000000 00000000
kern.info kernel: CPU: L1 I cache: 16K, L1 D cache: 16K
kern.info kernel: CPU: L2 cache: 256K
kern.notice kernel: CPU serial number disabled.
kern.debug kernel: CPU: After all inits, caps: 0383f9ff 00000000 00000000 00000040 00000000 00000000 00000000
kern.info kernel: Intel machine check architecture supported.
kern.info kernel: Intel machine check reporting enabled on CPU#0.
kern.warn kernel: Compat vDSO mapped to ffffe000.
kern.warn kernel: CPU: Intel Pentium III (Coppermine) stepping 0a
kern.info kernel: Checking 'hlt' instruction... OK.
kern.info kernel: checking if image is initramfs... it is
kern.info kernel: Freeing initrd memory: 1192k freed
kern.info kernel: NET: Registered protocol family 16
kern.info kernel: EISA bus registered
kern.info kernel: PCI: PCI BIOS revision 2.10 entry at 0xfd81e, last bus=1
kern.info kernel: PCI: Using configuration type 1
kern.warn kernel: Setting up standard PCI resources
kern.info kernel: ACPI: Interpreter disabled.
kern.info kernel: Linux Plug and Play Support v0.97 (c) Adam Belay
kern.info kernel: pnp: PnP ACPI: disabled
kern.info kernel: PnPBIOS: Scanning system for PnP BIOS support...
kern.info kernel: PnPBIOS: Found PnP BIOS installation structure at 0xc00f7050
kern.info kernel: PnPBIOS: PnP BIOS version 1.0, entry 0xf0000:0x82da, dseg 0x400
kern.info kernel: PnPBIOS: 19 nodes reported by PnP BIOS; 19 recorded by driver
kern.notice kernel: SCSI subsystem initialized
kern.warn kernel: PCI: Probing PCI hardware
kern.debug kernel: PCI: Probing PCI hardware (bus 00)
kern.warn kernel: PCI quirk: region 8100-810f claimed by vt82c686 SMB
kern.debug kernel: Boot video device is 0000:01:00.0
kern.info kernel: PCI: Using IRQ router VIA [1106/0686] at 0000:00:07.0
kern.debug kernel: PCI: setting IRQ 4 as level-triggered
kern.info kernel: PCI: Found IRQ 4 for device 0000:00:07.5
kern.info kernel: IRQ routing conflict for 0000:00:0c.1, have irq 10, want irq 4
kern.info kernel: pnp: 00:0a: ioport range 0x4d0-0x4d1 has been reserved
kern.info kernel: pnp: 00:0a: ioport range 0x8000-0x807f has been reserved
kern.info kernel: pnp: 00:0a: ioport range 0x8100-0x810f has been reserved
kern.info kernel: pnp: 00:0b: ioport range 0x3400-0x347f has been reserved
kern.info kernel: PCI: Bridge: 0000:00:01.0
kern.info kernel: IO window: disabled.
kern.info kernel: MEM window: e01000
kern.info kernel: 00-e01fffff
kern.info kernel: PREFETCH window: f0000000-f7ffffff
kern.warn kernel: PCI: Bus 2, cardbus bridge: 0000:00:0c.0
kern.warn kernel: IO window: 00002000-000020ff
kern.warn kernel: IO window: 00002400-000024ff
kern.warn kernel: PREFETCH window: 20000000-21ffffff
kern.warn kernel: MEM window: 22000000-23ffffff
kern.warn kernel: PCI: Bus 6, cardbus bridge: 0000:00:0c.1
kern.warn kernel: IO window: 00002800-000028ff
kern.warn kernel: IO window: 00002c00-00002cff
kern.warn kernel: PREFETCH window: 24000000-25ffffff
kern.warn kernel: MEM window: 26000000-27ffffff
kern.debug kernel: PCI: Setting latency timer of device 0000:00:01.0 to 64
kern.debug kernel: PCI: setting IRQ 10 as level-triggered
kern.info kernel: PCI: Assigned IRQ 10 for device 0000:00:0c.0
kern.info kernel: PCI: Sharing IRQ 10 with 0000:00:06.0
kern.info kernel: PCI: Sharing IRQ 10 with 0000:00:0d.0
kern.debug kernel: PCI: Setting latency timer of device 0000:00:0c.0 to 64
kern.info kernel: PCI: Found IRQ 4 for device 0000:00:0c.1
kern.info kernel: PCI: Sharing IRQ 4 with 0000:00:07.5
kern.info kernel: IRQ routing conflict for 0000:00:0c.1, have irq 10, want irq 4
kern.debug kernel: PCI: Setting latency timer of device 0000:00:0c.1 to 64
...
kern.info kernel: Linux Tulip driver version 1.1.13 (May 11, 2002)
kern.warn kernel: PCI: Enabling device 0000:00:05.0 (0000 -> 0003)
kern.warn kernel: PCI: No IRQ known for interrupt pin A of device 0000:00:05.0. Please try using pci=biosirq.
kern.debug kernel: PCI: Setting latency timer of device 0000:00:05.0 to 64
kern.info kernel: tulip0: MII transceiver #1 config 3000 status 786d advertising 01e1.
kern.info kernel: eth0: ADMtek Comet rev 17 at 00011c00, 00:90:96:1D:F2:15, IRQ 0.
--------------------------------------------------------------------------------------------

When I am running the eth0 test the result is 'Puppy was able to to find live network' .
But, it is the same for 'Auto DHCP' and 'Static IP setup', I get this 'interface configuration failed, please try again' message.

------------------------------------------ log for interface conf ----------------------------
kern.err kernel: IRQ handler type mismatch for IRQ 0
kern.warn kernel: [<c01342fc>] setup_irq+0xcc/0x170
kern.warn kernel: [<df961b70>] tulip_interrupt+0x0/0x900 [tulip]
kern.warn kernel: [<c013451f>] request_irq+0x7f/0xa0
kern.warn kernel: [<df96460b>] tulip_open+0x1b/0x50 [tulip]
kern.warn kernel: [<df961b70>] tulip_interrupt+0x0/0x900 [tulip]
kern.warn kernel: [<c0302313>] dev_open+0x63/0x80
kern.warn kernel: [<c0303a39>] dev_change_flags+0x49/0x110
kern.warn kernel: [<c033ec75>] devinet_ioctl+0x495/0x540
kern.warn kernel: [<c03408c5>] inet_ioctl+0x85/0xa0
kern.warn kernel: [<c02f8bad>] sock_ioctl+0xdd/0x240
kern.warn kernel: [<c01634c5>] do_ioctl+0x55/0x70
kern.warn kernel: [<c0163604>] vfs_ioctl+0x54/0x1e0
kern.warn kernel: [<c01637bd>] sys_ioctl+0x2d/0x50
kern.warn kernel: [<c0102f07>] syscall_call+0x7/0xb

I am not sure that this will enough for investigation. But, I hope.

I have tryed the pci=biosirq. I had the same result.

It has PhoenixBIOS 4.0 Release 6.0

Thank you for your kindest help

[w0lfskin]

I haven;t been able to figure out my accton 2242 either... if you have any luck, please let me know