Posted: Sat 15 Sep 2007, 18:12 Post subject:
ipw3945 can be in monitor mode???
I installed puppy 1,17.1 everything works perfect
i did " iwconfig ipw3945 eth1 mode 2" for monitor and it accepts its
i configures kismet everything ok.but when i recieve kismet it shows that message
FATAL: Failed to set monitor mode: Invalid argument. This usually means your drivers either do not support monitor mode, or use a different mechanism for getting to it. Make sure you have a version of your drivers that support monitor mode, and consult the troubleshooting section of the README.
Joined: 10 Jun 2005 Posts: 5472 Location: Australia
Posted: Mon 17 Sep 2007, 00:15 Post subject:
Re: ipw3945 can be in monitor mode???
Here is the ipw3945 module for Puppy 2.17 compiled with these options enabled in the Makefile:
Significantly, this module should now create the additional interfaces "rtap0" and "wifi0", which will allow it to be used with aircrack-ng. Here is a HOWTO -
This HOWTO refers to a distribution called "wifiway-0.6" which contains a completely rewritten version of the ipw3945 module called "ipraw".
To get the rtap0 interface, the module needs to be unloaded, then reloaded -
modprobe ipw3945 rtap_iface 1
... it might also be necessary to put the device into monitor mode, I'm not sure.
If this is true, the commands would be -
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You can download files in this forum