Search found 7 matches
- Thu 30 Apr 2009, 17:19
- Forum: Cutting edge
- Topic: MicroClient JrDX and Puppy Linux 4.1.2
- Replies: 2
- Views: 2794
No luck with 4.1.2 or 4.2 here, but I have a solid install of Puppy 4.0 on the MicroClient JrDX aka eBox 3300. Enable PCI IDE Bus Master in BIOS Verify IDE operate mode is set to Legacy in BIOS Change ATA cable detection to Device in BIOS Change USB 2.0 controller mode to Full Speed in BIOS Boot fro...
- Thu 24 Jan 2008, 13:35
- Forum: Beginners Help ( Start Here)
- Topic: eBox (eTC) 3854 thin client + Puppy + Firefly Media Server
- Replies: 1
- Views: 1744
- Thu 20 Dec 2007, 13:45
- Forum: Puppy Derivatives
- Topic: eBoxPup-2.13-0.1alpha released
- Replies: 124
- Views: 111387
The 2300SX is quite different than the original eBox-2300. See this thread for details: http://www.murga-linux.com/puppy/viewto ... 73&t=21864
- Fri 14 Dec 2007, 20:37
- Forum: Cutting edge
- Topic: eBoxPup - a custom eBox-2300 Puppy - suggestions needed
- Replies: 29
- Views: 25240
I can confirm that the last time buy date has been pushed out to February 28, 2008. This is the final date that distributors and resellers can place orders for this model, but the channel should be able to supply end users with small quantities for several months after this date. I don't have anythi...
- Wed 12 Dec 2007, 13:53
- Forum: Cutting edge
- Topic: ebox 2300sx is ready
- Replies: 110
- Views: 148289
All flash memory has a write endurance specification. Commercial modules typically endure 100,000+ write/erase cycles. Some Industrial spec modules handle up to 3,000,000 cycles. Also, many flash modules have built-in wear leveling. This means that the write/erase cycles are distributed across the e...
- Mon 10 Dec 2007, 03:39
- Forum: Cutting edge
- Topic: ebox 2300sx is ready
- Replies: 110
- Views: 148289
Raffy: thanks for clearing that up. I use an older Puppy cd pretty regularly with a USB CD-ROM drive... I was thinking it was version 2.14, but it might be 2.16. Photonn: thanks for the encouragement. If time allows, maybe I can roll up my sleeves with you. On a personal level, I'd like to set up on...
- Fri 07 Dec 2007, 18:05
- Forum: Cutting edge
- Topic: ebox 2300sx is ready
- Replies: 110
- Views: 148289
First, a quick introduction. I'm Donnie. I do pre-sales support at WDL Systems, although I try to help out with some post-sales technical support before sending folks to the manufacturer for help. I wanted to get that out of the way since I don't think I've actually posted here before. Secondly, I t...