There is a module loaded: sh-4.1# modprobe -l|grep af903x kernel/drivers/media/dvb/dvb-usb/dvb-usb-af903x.ko but it ends in error: usb 1-3: new high speed USB device using ehci_hcd and address 5 DRIVER_RELEASE_VERSION : v9.08.14.1 FW_RELEASE_VERSION : v8_8_63_0 API_RELEASE_VERSION : 200.20090402.0 [...

W_scan works! Saying that there is no driver loaded ... : sh-4.1# w_scan w_scan version 20111011 (compiled for DVB API 5.1) guessing country 'NL', use -c <country> to override using settings for NETHERLANDS DVB aerial DVB-T Europe frontend_type DVB-T, channellist 4 output format vdr-1.6 output chars...

Nothing yet .... let me send you a PM! dvb_usb_af903x: probe of 1-3:1.0 failed with error -12 usbcore: registered new interface driver dvb_usb_af903x usb 1-3: USB disconnect, address 4 usb 1-3: new high speed USB device using ehci_hcd and address 5 DRIVER_RELEASE_VERSION : v9.08.14.1 FW_RELEASE_VERS...

Thanks for the .pet! After rebooting, dmesg reports an error. Can you help? usb 1-3: new high speed USB device using ehci_hcd and address 4 AF903X: af903x_module_init DRIVER_RELEASE_VERSION : v9.08.14.1 FW_RELEASE_VERSION : v8_8_63_0 API_RELEASE_VERSION : 200.20090402.0 [Device_init] Error 1 dvb_usb...

I've found and copied driver dvb-usb-af9035-01.fw to /lib/firmware Unfortunately the kernel does not associate the stick with the driver: usb 1-3: new high speed USB device using ehci_hcd and address 4 input: Afa Technologies Inc. AF9035A USB Device as /devices/pci0000:00/0000:00:1d.7/usb1/1-3/1-3:1...

After plugging in, the kernel seems to recognize the USB-stick. It needs the AF9035-driver. How to make it work in Puppy? Puppy Linux 5.28 sh-4.1# uname -r 2.6.33.2 dmesg: usb 1-2: new high speed USB device using ehci_hcd and address 7 input: Afa Technologies Inc. AF9035A USB Device as /devices/pci0...

Thanks for your help so far.
Most important now is the get the cam working, if it can.

I leave it now for a while.

'No valid video chain found'

And: 'OHCI Host Controller - Unknown USB 2.00 Device (class 239).'

I think something goes wrong at the USB.

Quicky does not do anything with the airo_cs driver for the Cisco Aironet 350 pcmcia.

In puppy 4.2.1 everything was fine. No problems with the Network Whizzard.

Thanks, HJ.

Thanks, in Quicky I do not see the 'no video chain' error message. Unfortunately there is another one: I cannot connect via the wireless card.

After selecting the driver, the card does not become active.

The same for Wary

The USB-bus does not recognize the Logitech C120 cam. However another USB-device such as a USB-stick is fully recognized. HardInfo says: OHCI Host Controller - Unknown USB 2.00 Device (class 239) dmesg -l |grep uvc says: uvcvideo: Found UVC 1.00 device <unnamed> (046d:080f) uvcvideo: No valid video ...